- #Steamvr compositor not available drivers#
- #Steamvr compositor not available driver#
- #Steamvr compositor not available Pc#
Blinking Red: Low battery - charge your controllers by plugging them into an outlet with the included micro-USB cord and power adapter. Blue: Connecting - if it stays in this state, you can pair your controller by going to SteamVR > Settings > Devices > Pair Controller. You may need to re-pair their controller if it’s in the blue blinking state (SteamVR > Settings > Devices > Pair Controller). The controller should turn on, and make a different noise than the standard one. While holding the Trigger and the Menu button, press the system button. Turn off controller (long press System button). If your controller's touchpad is twitchy and oversensitive, it needs to be calibrated. Re-pair your controllers by going to SteamVR > Settings > Devices > Pair Controller If the light is blue, it is not successfully connecting. While plugged in, orange indicates charging, and white indicates fully charged. Charge controllers by plugging them into an outlet with the included micro-USB cord and power adapter. Turn on the controller by pressing the system button (lowest button on the controller) Make sure the controller is charged and on. #Steamvr compositor not available driver#
Red or blinking red: Cable or driver error. Moving your headset or starting a VR application will wake it up. Make sure to plug it into your computer's graphics card. Use the included HDMI cable to connect the Link Box to your PC. If you continue to have issues, try a USB 2.0 port.) (Vive supports USB 2.0 or greater, but we have encountered issues with certain USB 3.0 ports. Use the included USB cable to connect the Link Box to an available USB port on your PC. Plug the power cord into the Link Box, and plug it into a power outlet. If you have a first generation Vive Development Kit, do not mix and match the parts. 
Plug all three of these into the side of the Link Box with orange ports.
The end of your Headset's tether has three orange tipped cords (USB, HDMI, and Power). Make sure the headset is properly plugged in:. Check to make sure you have the latest video drivers. The orange tipped cables from the Headset should be connected to the orange ports on the Link Box. Make sure your Link Box is installed in the correct direction. To check this remove cable panel on top of the HMD by pushing it forward. The power cord on the HMD itself can become loose from usage. Make sure all cables are connected firmly. This error can have a number of solutions, so please work from the list below to make sure you've attempted all available solutions: You can try plugging into the same USB port as well as different USB ports.Įrror 208 (HMD detected over USB, but monitor not found) is a generic HMD error message. You may need to repeat the steps above more than once. #Steamvr compositor not available drivers#
You may see more drivers install, wait for this to finish.
Wait a few seconds, then plug it all back in. #Steamvr compositor not available Pc#
Unplug the Link Box from the PC and power (USB, HDMI, Power).Make sure your default audio playback device is set to HTC-VIVE-0.Įrror 108 (Headset not found) may be a USB / driver issue.Set NVIDIA power management to "prefer maximum performance" as described here:.For troubleshooting for the first generation development kit, click here. This is the troubleshooting guide for the HTC Vive Pre + SteamVR. 2 SteamVR + HTC Vive Pre Troubleshootingįor instructions on first time setup and installation of your Vive Pre, please see the installation guide.
0 kommentar(er)
